Summary of ISO/TC 201 standard: XXI. ISO 21270:2004—Surface chemical analysis—X‐ray photoelectron and Auger electron spectrometers—Linearity of intensity scale

This International Standard specifies two methods for determining the maximum count rate for an acceptable limit of divergence from linearity of the intensity scale of Auger and x‐ray photoelectron spectrometers. It also includes methods to correct for intensity non‐linearities so that a higher maximum count rate can be employed for those spectrometers for which the relevant correction equations have been shown to be valid. Copyright © 2004 John Wiley & Sons, Ltd.     

Improved accuracy of quantitative XPS analysis using predetermined spectrometer transmission functions with UNIFIT 2004

The accuracy of quantitative XPS analysis can be improved using predetermined transmission functions. Two different calibration methods are used for estimating the transmission function T(E) of a photoelectron spectrometer, applying a survey spectra approach (SSA) and a quantified peak‐area approach (QPA) to minimize the quantification error. For the SSA method, Au, Ag and Cu spectra measured with the Metrology Spectrometer II have been used. The new QPA method was built up from Au 4f, Au 4d, Au 4p_3/2, Ag 3d, Ag 3p_3/2, Cu 3p, Cu 2p_3/2, Ge 3p and Ge 2p_3/2 standard peak areas, applying adequate ionization cross‐sections and mean free path lengths for different pass energies (10 and 50 eV), lens modes (large area, large area XL, small area 150) and x‐ray sources (Al/Mg Twin and Al Mono). In the energy range 200–1500 eV a transmission function T(E) = a₀ + b₁E (where a₀, b₁ and b₂ are variable parameters) was found to give an appropriate approximation for eight tested spectrometer settings, implementing the largest changes in the case of pass energy variations. Determination and application of the transmission functions were integrated in the XPS analysis software (UNIFIT 2004) and tested by means of an Ni90Cr10 alloy. The results demonstrate the practicability of the SSA and QPA methods, giving decreased errors of <8% in comparison with errors up to 38% obtained using Wagner's sensitivity factors. Copyright © 2005 John Wiley & Sons, Ltd.     

Vibronic intensities in centrosymmetric coordination compounds of the rare earths Part II. A vibronic crystal field-closure-ligand polarisation model and applications to the PrCl6 and UBr6 complex ions in octahedral symmetry

A symmetry adapted formalism to evaluate the vibronic intensities induced by the ungerade vibrational modes in centrosymmetric coordination compounds of the rare earths is put forward and applied to several selected electronic transitions of the PrCl³⁻₆ and UCl²⁻₆ complex ions in octahedral symmetry. This current model is based upon a modified symmetry adapted version of the combined vibronic crystal field-closure-ligand polarisation approach. This model differs from that developed in Part I of this series, in that for the vibronic crystal field contribution to the total transition dipole moment, the closure procedure is employed rather than the utilisation of a truncated basis set for the central metal intermediate electronic states. A criterion is introduced to choose an appropriate set of phases for both the electronic and the vibrational coordinates so that to ensure the right sign for the interference term (which couples together both the vibronic crystal field and the vibronic ligand polarisation contributions to the total transition dipole moment). We have focused our attention on the modulation of the intermolecular force field and a version of a modified general valence force field has been adopted. The reasons for using this formalism rather than the superposition model (SM) are fully discussed in the text. Finally, it is shown that the agreement with experiment is satisfactory for most of the components of the transitions studied, despite the apparent simplicity of our model calculation. General master equations applicable to any f^N electronic configurations are derived to show the utility and flexibility of this current formalism.     

Chemical-effect variation of Kβ/Kα X-ray intensity ratios in 3d elements

Chemical effects on Kβ/Kα X-ray intensity ratios for some Ti, V, Cr, Mn, Fe, Co, Ni, Cu and Zn compounds are studied experimentally. The X-ray spectra were measured by using a Si (Li) solid state detector with high resolution. The vacancies were produced by heavily filtered ²⁴¹Am gamma rays. It is found that the Kβ/Kα X-ray intensity ratios measured with compounds deviated up to 43% from the corresponding values of the pure elements. The values for pure elements are compared with the other experimental and with theoretical values.     

助熔剂对Y3Al5O12：Ce荧光粉性能的影响

在还原气氛下采用高温固相反应法合成了白光LED用黄色荧光粉Y3Al5O12:Ce(YAG:Ce)研究了助熔剂对YAG：Ce荧光粉发光特性的影响，。XRD的测量结果表明加入合适的助熔剂有利于YAG:Ce荧光粉的晶化，并且不引入杂相，选择BaF2和H3BO3同时使用效果要好于单独使用一种助熔剂，助熔剂的加入可增大YAG：Ce荧光粉的激发和发射光谱强度，并能有效降低荧光粉的中心粒径（D50）控制粉体的粒径分布，适用于白光LED的制造。     

Distance-dependent fluorescence quenching ofN-acetyl-l-tryptophanamide by acrylamide

We examined the time-dependent intensity decays ofN-acetyl-l-tryptophanamide (NATA) when collisionally quenched by acrylamide in propylene glycol over a range of temperatures. The intensity decays of NATA became increasingly heterogeneous in the presence of acrylamide. The NATA intensity decays were not consistent with the Collins-Kimball radiation boundary condition (RBC) model for quenching. The steady-state Stern-Volmer plots show significant upward curvature, and quenching of NATA by acrylamide was observed even in vitrified propylene glycol, where translational diffusion cannot occur during the lifetime of the excited state. These frequencydomain and steady-state data indicate a through-space quenching interaction between NATA and acrylamide, and the results are consistent with a rate constant for quenching that depends exponentially on the fluorophore-quencher separation distance. The exponential distance-dependent rate of quenching also explains the upward curvature of the Stern-Volmer plot, and the steady-state data aid in determining the interaction distance between NATA and acrylamide. These results suggest that the distance-dependent quenching rates need to be considered in the interpretation of acrylamide quenching of proteins.     

Microenvironmental differences amongst micelles of various shapes and structures

Micelles of different amphiphiles adopt different shapes and internal packing arrangements in water, depending on their chemical structures and the conditions of the medium. Two microenvironmental features, namely the polarity and the microviscosity that the aggregate offers to a solubilized molecule, have been monitored using extrinsic fluorescence probes. While the differences between micelles of spherical and rod-like shapes are not always distinct, stacked micelles and peptide micelles offer distinctly lower polarity and higher microviscosity to solubilizates than the others.     

Methods of theoretical study of vibrational phenomena in liquids--comparative analysis

In this review, existing theoretical models of vibrational phenomena in liquids are analyzed and compared. Most attention is paid to sonoluminescence, sonolysis and related phenomena. The criteria of selection of the optimal theoretical model involve analyzing experimental results, its usefulness for evaluation of thermodynamic and other parameters of the liquid under vibration, simplicity of the mathematical solution and the time needed for computing. It is concluded that, according to these criteria, the optimal (between existing models) is the chemical model of vibration in liquid, while the best perspectives are for its combinations with other models.     

吡啰红B为指示剂细胞色素C催化荧光测定青蒿素

在细胞色素C催化下,吡啰红B与青蒿素反应导致荧光降低,细胞色素C与青蒿素的反应为酶-底物模型。动力学研究表明,稳态催化速率依赖于酶和底物浓度,催化常数Km、Vm ax及Kcat分别为3.3×10-5mol/L,5.4×10-6mol.L-1.s-1和13.5 s-1,催化活性受去活化剂和乙醇抑制。在pH 5.3、25℃及7.6×10-7mol/L的细胞色素C催化条件下,荧光降低值ΔF(F0-F)与青蒿素浓度在7.1×10-8~1.1×10-6mol/L范围内呈线性关系;检出限为7.2×10-9mol/L;加标回收率为96.3%~106.8%。方法已用于测定血浆和尿液介质中的微量青蒿素。